Boat Rudder Clamp for 1.125 Transom Trolling Motor Shaft from USA

Product Description The Bullnose Rudder (Patent no. US D712,341S) is a boat rudder that fits 1 1/8" (1.125") transom mount trolling motors, giving you better control of your watercraft in most windy conditions, helping to hold a true course at most trolling speeds, and preventing the boat from spinning as much when the motor is off. It is designed to give a superior performance compared to a trolling motor alone, making it an essential addition to your boating or fishing experience. The rudder measures 10.5" high x 4.75" wide and it is designed to clamp tightly to the trolling motor shaft, providing precision steering under various conditions such as wind or choppy water.

Installation It only takes a few minutes to install and you are ready to go. If the shaft is slimmer than 1 1/8" (1.125"), there is double-sided mounting tape provided in the packaging to shim a thin shaft.

Performance The rudder is designed to fit a transom trolling motor and has a unique shape to accommodate your prop. If there is not enough clearance between the shaft and the prop, simply flip it upside down. It will perform just the same while allowing the prop to spin freely without any interference.

Benefit Adding the Bullnose Rudder to your setup provides a more accurate course when fishing or boating, especially for small watercrafts such as kayaks, pontoons, jon boats, and canoes. It is the perfect solution for trolling motors that are known for lack of steering, providing better control in most windy conditions.

Quality Control The Bullnose Rudder is manufactured in the USA with high-quality parts and materials to ensure durability and performance under various conditions, providing a stress-free fishing experience. The rudder is constructed from impact plastic for durability and comes with stainless steel screws to prevent it from coming loose during use.

Bow Mount The rudder fits Minn Kota, EDGE, MAXXUM, and FORTREX motors. The bow mount motor must be a hand cable pull, NOT self deploy, as self-deploy motors will not work with the rudder. The shaft needs to slide up and down where the rudder needs to be attached, and a hand cable pull allows you to carefully bring the motor up out of the water on the motor mount.

Frequently Asked Questions The rudder is made for a 1 1/8" (1.125") diameter shaft and the clamps are not adjustable. However, there is double-sided foam tape provided in the packaging to shim a thin shaft for a secure fit. It will not fit a shaft larger than 1 1/8" (1.125"). The rudder is durable and will withstand salty waters, although the hardware may be prone to rust without proper care. It does not tend to collect excess plants or weeds, and is an essential addition to your boating or fishing experience.

product information: